
Roof Coatings and Restoration Albuquerque and New Mexico
Roof Coatings in Albuquerque. Restore the Roof You Have.
If your flat roof is worn but still dry and sound, a silicone coating can seal it, reflect the sun and add years of service without a tear-off. Sunwest Roofing tells you honestly whether your roof is a candidate, then does the prep work that makes a coating last.
- Silicone coating systems
- No tear-off on qualifying roofs
- Repairs made before coating
The short answer
Do roof coatings work in Albuquerque?
Yes, on the right roof. A silicone roof coating is a liquid applied over an existing flat or low-slope roof that cures into a seamless, reflective, waterproof layer. In Albuquerque, NM, silicone is a good fit because it resists strong ultraviolet light and holds up under ponding water after monsoon storms. A coating only works when the roof under it is dry and structurally sound, so the roof must be inspected, repaired and cleaned first. Sunwest Roofing LLC, at 7026 2nd St NW in Albuquerque, installs silicone coating systems including Gaco and holds New Mexico license GS-21 394415.
What a Roof Coating Does
A coating is not paint. It is a thick, rubber-like layer applied over the whole roof, built up to a specified thickness, with every seam and flashing treated first.
It seals small cracks and pinholes, protects the roof under it from the sun, and turns a dark, hot roof into a bright, reflective one.
Because the old roof stays in place, there is far less noise, debris and disruption than a tear-off. For a business that cannot shut down, that matters.
Roofs That Can Be Coated
A coating can go over most low-slope roof types, as long as the roof is dry and well attached.
Metal roofs.
Seams and fasteners are sealed first, then the whole roof is coated to stop leaks and rust.
Modified bitumen.
Granulated and smooth cap sheets that are worn but still bonded.
Built-up roofs.
Tar and gravel or smooth built-up roofs, prepared to the coating manufacturer's specification.
TPO, PVC and EPDM.
Aged single-ply membranes with sound seams and flashings.
Spray foam roofs.
Foam roofs need their coating renewed to protect the foam from the sun.
Previously coated roofs.
Older coatings can often be cleaned and recoated.
When a Coating Is the Wrong Answer
We turn down coating jobs when the roof will not hold one. Coating over a bad roof wastes your money.
- Wet insulation. A coating traps moisture that is already in the roof. Wet areas must be cut out and replaced first, and if they are widespread the roof needs replacement.
- A roof that is letting go. If the membrane is loose, badly blistered or failing at the seams everywhere, there is nothing solid to coat.
- Structural or deck problems. A coating does nothing for a damaged deck.
- Skipped prep. Most coating failures come from poor cleaning and untreated seams, not from the product.
Why Silicone, and Why Gaco
Albuquerque roofs take intense sun all year and standing water after summer storms. Silicone handles both.
Gaco is one of the best known names in silicone roof coatings. Its GacoFlex silicone systems are 100 percent silicone, made to go over most existing roof surfaces, and built to stand up to ultraviolet light and ponding water.
Gaco offers labor and material warranties on coating systems installed to its specification by qualified applicators. We will tell you what warranty your roof and the chosen system qualify for before work begins.
How Sunwest Installs a Coating System
- 01
Assessment.
A roof walk with dated photos to confirm the roof is dry, attached and a real candidate.
- 02
Repairs.
Wet areas replaced, seams, flashings, drains and penetrations repaired and reinforced.
- 03
Cleaning.
The roof is power washed so the coating bonds to the roof, not to dirt.
- 04
Primer where needed.
Some surfaces need a primer or an adhesion test first. We follow the manufacturer's specification.
- 05
Coating applied to thickness.
Applied at the specified rate and checked, with photos of the finished roof for your records.
Coating or Replacement? We Will Show You
Both are good answers on the right roof. The roof decides, and we show you the evidence.
If a coating fits, you get a restored, reflective roof with far less disruption. If the roof is past that point, we explain what commercial roof replacement would involve and what system makes sense.
Either way, our Roof Management Program keeps the roof inspected so small problems are fixed before they become leaks.
Questions Owners Ask
How long does a silicone roof coating last?
It depends on the product, the thickness applied and the condition of the roof under it. Manufacturer warranties on silicone coating systems are commonly offered in terms such as 10 years or longer. A coated roof can usually be cleaned and recoated at the end of that period.
Will a roof coating stop my leaks?
A coating seals small cracks, pinholes and worn surfaces. Active leaks from open seams, failed flashings or damaged areas have to be repaired first. The coating then protects those repairs and the rest of the roof.
Can you coat a roof that has ponding water?
Silicone is made to withstand ponding water without softening or breaking down, which is why it is used on flat roofs. We still look for the cause of the ponding, because a clogged drain or crushed insulation should be fixed, not just coated over.
Is a roof coating cheaper than a new roof?
On a roof that qualifies, restoration with a coating generally costs less than a tear-off and new system because the existing roof stays in place. If the roof is wet or failing, a coating is not a saving. It is money spent twice.
Do roof coatings help with cooling costs?
A white reflective coating lowers the surface temperature of the roof under the New Mexico sun, which reduces the heat load on the building. How much you save depends on your insulation, your equipment and how the building is used.
Find Out if Your Roof Can Be Restored
We will walk the roof, photograph it and tell you straight whether a coating makes sense.
Serving Albuquerque, Rio Rancho, Santa Fe and communities across New Mexico.